Adiabatic two-step photoexcitation effects in intermediate-band solar cells with quantum dot-in-well structure.

We studied the dynamics of electrons generated by two-step photoexcitation in an intermediate-band solar cell (IBSC) comprising InAs/GaAs/Al0.3Ga0.7As dot-in-well (DWELL) structure using time-resolved photocurrent (TRPC) measurement. The examined IBSC exhibited considerably slower photocurrent decay than a conventional InAs/GaAs quantum dot IBSC, which is due to the extraordinarily long-lived electrons in the DWELL. In order to retrieve the electron lifetime from the decay profile, we developed a model reproducing the observed decay and performed parameter fitting. The fitting results indicate that the electron lifetime in the DWELL is approximately 30 µs. In the two-colour excitation TRPC measurement, we found that an additional infrared (IR) light accelerates the photocurrent decay while the photocurrent increases by approximately 3%, because the additional IR light causes two-step photoexcitation of electrons in the DWELLs towards the conduction band. Furthermore, we demonstrated that the open-circuit voltage increases with increasing of the contribution of the second IR excitation process.

Two-step photon up-conversion solar cells.

Reducing the transmission loss for below-gap photons is a straightforward way to break the limit of the energy-conversion efficiency of solar cells (SCs). The up-conversion of below-gap photons is very promising for generating additional photocurrent. Here we propose a two-step photon up-conversion SC with a hetero-interface comprising different bandgaps of Al0.3Ga0.7As and GaAs. The below-gap photons for Al0.3Ga0.7As excite GaAs and generate electrons at the hetero-interface. The accumulated electrons at the hetero-interface are pumped upwards into the Al0.3Ga0.7As barrier by below-gap photons for GaAs. Efficient two-step photon up-conversion is achieved by introducing InAs quantum dots at the hetero-interface. We observe not only a dramatic increase in the additional photocurrent, which exceeds the reported values by approximately two orders of magnitude, but also an increase in the photovoltage. These results suggest that the two-step photon up-conversion SC has a high potential for implementation in the next-generation high-efficiency SCs.

Quantum size effects in GaAs nanodisks fabricated using a combination of the bio-template technique and neutral beam etching.

We successfully fabricated defect-free, distributed and sub-20-nm GaAs quantum dots (named GaAs nanodisks (NDs)) by using a novel top-down technique that combines a new bio-template (PEGylated ferritin) and defect-free neutral beam etching (NBE). Greater flexibility was achieved when engineering the quantum levels of ND structures resulted in greater flexibility than that for a conventional quantum dot structure because structures enabled independent control of thickness and diameter parameters. The ND height was controlled by adjusting the deposition thickness, while the ND diameter was controlled by adjusting the hydrogen-radical treatment conditions prior to NBE. Photoluminescence emission due to carrier recombination between the ground states of GaAs NDs was observed, which showed that the emission energy shift depended on the ND diameters. Quantum level engineering due to both diameter and thickness was verified from the good agreement between the PL emission energy and the calculated quantum confinement energy.